Carregant...
Fitxers
Tipus de document
ArticleVersió
Versió publicadaData de publicació
Llicència de publicació
Si us plau utilitzeu sempre aquest identificador per citar o enllaçar aquest document: https://hdl.handle.net/2445/221423
Manufacturing and properties characterization of Ti patterned coatings for water electrolyzers by CSAM
Títol de la revista
Director/Tutor
ISSN de la revista
Títol del volum
Recurs relacionat
Resum
This work investigates the microstructure and manufacturing control of the masked Cold Spray Additive Manufacturing (CSAM) strategy for producing of new bipolar plates (BPPs) for Proton Exchange Membrane (PEM) electrolyzers, using low-cost, lightweight, and machinable materials. CSAM is a solid-state process capable of fabricating 3D patterned parts based on a bottom-up approach using masks with a desired pattern. This study focuses on the dimensional and microstructural characteristics of pin fins fabricated with spherical (Ti-S) and irregular (Ti-I) Ti powders using the masked CSAM technology. Additionally, the performance of both Ti parts for its application in PEM electrolyzers was evaluated in terms of corrosion resistance and interfacial contact resistance (ICR). The results demonstrated that the masked CSAM technology allowed precise control and customization of the dimensions of the 3D-printed pin fins, obtaining porosity values of 6 ± 1 % for Ti-S and 4 ± 1 % for Ti-I. The evaluation of the corrosion resistance of the CSAM Ti patterned parts showed that for both Ti-S and Ti-I powders a stable oxide film at the typical operation potential (1.8 V vs Ag/AgCl) of a PEM water electrolyzer was formed without signs of pitting corrosion. Finally, at a compaction pressure of 150 N/cm2 ICR values of 42 ± 19, 40 ± 13, and 24 ± 7 mΩ·cm2 were obtained for Ti-I, Ti-S, and standard Ti Bulk, respectively. The results suggest than the masked CSAM technology shows great potential for the fabrication of Ti BPPs.
Matèries
Matèries (anglès)
Citació
Citació
GARFIAS BULNES, Andrea, SARRET I PONS, Maria, SANCHEZ, Javier, GARCÍA CANO, Irene, ALBALADEJO-FUENTES, Vicente, ANDREU ARBELLA, Teresa. Manufacturing and properties characterization of Ti patterned coatings for water electrolyzers by CSAM. _Applied Surface Science Advances_. 2024. Vol. 24. [consulta: 24 de gener de 2026]. [Disponible a: https://hdl.handle.net/2445/221423]