Fitxers

556353.pdf (3.12 MB)

Tipus de document

Article

Versió

Versió acceptada

Data de publicació

2009-02

Tots els drets reservats

Si us plau utilitzeu sempre aquest identificador per citar o enllaçar aquest document: https://hdl.handle.net/2445/110905

Influence of Matrix Type on Surface Roughness of Three Resins for Provisional Crowns and Fixed Partial Dentures

Títol de la revista

Autors

Director/Tutor

ISSN de la revista

Títol del volum

Recurs relacionat

https://doi.org/10.1111/j.1532-849X.2008.00392.x

Resum

Purpose: This study evaluated the effect of matrix type on the surface roughness of resins for provisional crowns and fixed partial dentures. Materials and methods: Ninety specimens of two acrylic resins (Trim II, Tab2000) and one bis-acryl composite (Protemp II Garant) were fabricated using one of three matrices: irreversible hydrocolloid (Cavex CA37), poly(vinyl siloxane) (Aquasil) or vacuum-formed matrix (Bio-flow Hard). The sample size for each resin-matrix combination was 10. The vestibular face of one natural maxillary central incisor was used as a model to fabricate all the specimens, following the custom fabrication technique. The average roughness measurements, Ra (mum), were obtained using a profilometer, and the data were analyzed using Kruskal-Wallis and Mann-Whitney U-tests. The results were contrasted against the surface roughness of the tooth using a one-sample t-test. Results: Aquasil and vacuum-formed matrix had a smoother surface than Cavex CA37 regardless of the resin tested (p < 0.05). Protemp II Garant had the smoothest surface regardless of the matrix used, with no significant differences when polymerized against the three different matrices. Trim II polymerized against Cavex CA37 had a rougher (p < 0.05) surface than Aquasil or vacuum-formed matrix. Tab2000 had the smoothest surface (p < 0.05) when polymerized against a vacuum-formed matrix. Conclusions: There is no universal matrix that produces the smoothest surface: this depends on the compatibility between the resin and the matrix. Protemp II Garant polymerized against Cavex CA37 matrix yields a surface that is smooth enough not to require polishing unless this surface is adjusted.

Matèries

Pròtesis dentals, Dents, Materials dentals, Resines acríliques, Odontologia

Matèries (anglès)

Dental prosthesis, Teeth, Dental materials, Acrylic resins, Dentistry

Citació

Col·leccions

Articles publicats en revistes (Odontoestomatologia)

Citació

AYUSO MONTERO, Raúl, et al. Influence of Matrix Type on Surface Roughness of Three Resins for Provisional Crowns and Fixed Partial Dentures. Journal of Prosthodontics. 2009. Vol. 18, num. 2, pags. 141-144. ISSN 1059-941X. [consulted: 9 of September of 2026]. Available at: https://hdl.handle.net/2445/110905

Exportar metadades

JSON - METS

Compartir registre